Windows / Code / 0xc100f032
0xc100f032
Decimal: 3238064178 · Signed: -1056903118
As HRESULT:- S: 1 (Failure)
- R: 1 (Reserved, must be clear in a well-formed HRESULT)
- C: 0 (Microsoft-defined)
- N: 0 (Not an NTSTATUS value)
- Facility: 0x100 (Unknown facility)
- Code: 0xf032 (61490)
As NTSTATUS:- Sev: 3 (STATUS_SEVERITY_ERROR)
- C: 0 (Microsoft-defined)
- Facility: 0x100 (Unknown facility)
- Code: 0xf032 (61490)
Associated Modules
| Module | Found in | Description |
|---|
| bcdedit.exe | 1011 | This command sets or displays the hypervisor settings for the system.
This command does not enable or disable the hypervisor debugger for any
particular OS loader entry. To enable or disable the hypervisor debugger for a
particular OS loader entry, use "bcdedit /set HYPERVISORDEBUG ON".
For information about identifiers, run "bcdedit /? ID".
To set an individual hypervisor debugger setting, use
"bcdedit /set {hypervisorsettings} ". For information about
valid types, run "bcdedit /? TYPES".
bcdedit /hypervisorsettings [ [DEBUGPORT:] [BAUDRATE:]
[CHANNEL:] [HOSTIP:] [PORT:] ]
Specifies the type of debugger. can be one of
SERIAL, 1394, or NET.
For SERIAL debugging, specifies the serial port to use as
the debugging port.
For SERIAL debugging, specifies the baud rate to be used
for debugging.
For 1394 debugging, specifies the 1394 channel to be used
for debugging.
For network debugging, specifies the IPv4 address of the
host debugger.
For network debugging, specifies the port to communicate
with on the host debugger. Should be 49152 or higher.
Examples:
The following command displays the current hypervisor settings:
bcdedit /hypervisorsettings
The following command sets the hypervisor debugger settings to serial debugging
over COM1 at 115,200 baud:
bcdedit /hypervisorsettings SERIAL DEBUGPORT:1 BAUDRATE:115200
The following command sets the hypervisor debugger settings to 1394 debugging
using channel 23:
bcdedit /hypervisorsettings 1394 CHANNEL:23
The following command sets the hypervisor debugger settings to network
debugging with a debugger host at 192.168.1.2 communicating on port 50000:
bcdedit /hypervisorsettings NET HOSTIP:192.168.1.2 PORT:50000 |
| 1 entry |
Associated Headers