netdacim.dll
Associated Error Codes
Below lists error codes and symbolic names found for this module.
| Code | Found in | Description |
|---|---|---|
| 0x1 | 8.11011 | Performing operation %1 on Target %2 |
| 0x2 | 8.11011 | Enabling site %1 for DirectAccess connectivity |
| 0x3 | 8.11011 | Disabling manual site selection for DirectAccess connectivity |
| 0x4 | 8.11011 | Invalid parameter: %1. |
| 0x5 | 8.11011 | Latency must be less than 1000ms. |
| 0x6 | 8.11011 | Each item in %1 must be of the form "%2". |
| 0x7 | 8.11011 | Only one %1 is supported. |
| 0x8 | 8.11011 | The specified interface was not found on the system. |
| 0x9 | 8.11011 | %1 must be a valid IPv6 prefix. |
| 0xa | 8.11011 | Failed to notify IP Helper Service of changes to local configuration. |
| 0xb | 8.11011 | This functionality is not supported on client SKUs. |
| 0xc | 8.11011 | The WinNAT service is stopped. Please start the service to display configuration from active store. |
| 0xd | 8.11011 | Failed to start WinNAT service. |
| 0xe | 8.11011 | %1 cannot contain a semicolon. |
| 0xf | 8.11011 | Only the following prefix lengths are allowed for NAT64: 32, 40, 48, 56, 64, and 96. |
| 0x10 | 8.11011 | Ports in port range must be in the range 1024-65535. |
| 0x11 | 8.11011 | To specify %1, %2 must also have a valid value. |
| 0x12 | 8.11011 | %1 and %2 cannot be specified at the same time. |
| 0x13 | 8.11011 | Must specify required parameter %1. |
| 0x14 | 8.11011 | Either %1 or %2 must be specified. |
| 0x15 | 8.11011 | The configuration has been corrupted. |
| 0x16 | 8.11011 | Cannot create or modify instances in the specified policy store. |
| 0x17 | 8.11011 | The specified %1 is already in use. |
| 0x18 | 8.11011 | None of the specified entry point ranges match the entry point IP address. |
| 0x19 | 8.11011 | The specified entry point ranges are not the best match for the entry point IP address. |
| 0x1a | 8.11011 | Entry point override has been restricted by your domain administrator. |
| 0x1b | 8.11011 | Network Connectivity Assistant service is stopped or not responding. |
| 0x1c | 8.11011 | ServerShunt and TCP Chimney can't be enabled together. TCP Chimney must be disabled for this operation. |
| 0x1d | 8.11011 | No entry points found with name equal to "%1". |
| 0x1e | 8.11011 | The TCP mapping timeout cannot be less than 30 minutes. |
| 0x1f | 8.11011 | State cannot be set to OutsideEnabled for server interfaces. |
| 31 entries | ||